Elk speaks "old" message when re-enabled?

[dbwarner5]

I have an Elk rule that at 11Pm, the voice gets disabled. and then at 7am it gets re-enabled. 

Meanwhile at 6am, my ISY controller disarms my system for me as part of a morning routine.  No announcement is made, as expected.

Then, later in the day, if I have some other ISY driven ELK announcement (ie: Garage door is Open), it always starts with "Area 1 disarmed, " then continues onto the new announcement. It is as if the 6am announcement gets saved in a que and then once the voice is re-enabled and a new message needs to be communicated, it dumps what is in the que first...

Have posted this in the Elk Forum, but no activity.

Any thoughts anyone? Thanks,

[BamBamF16]

Maybe similar to https://forum.universal-devices.com/topic/29590-disabled-voice-stores-old-messages-when-enabled/?

[blueman2]

FYI, this is a regular occurrence with me as well.  But mine will actually mix 2 messages together, blending words from each phrase.  Sometimes it is quite funny.  I never bothered to figure out why it was happening.  But yes, it is definitely a bug with ELK.  

[dbwarner5]

@bambamf16 @blueman2

Thanks for the link to my post from April.. lol. Had forgotten about it completely. I have since cleaned up my Elk and still get the same situation.

Blueman, thanks for collaborating what I have been seeing. I guess I will live with it and / or send a note to Elk Products and see what they say.  

 

[NHWA]

This was an issue for me too. Years ago I programmed my elk to turn off the speaker for 30 sec and speak after an arm/disarm so that there wasn't anything stored.

[dbwarner5]

@NHWA thanks..I’ll have to think about that.. i do all my programiong in Isy. This is the only elk programming i have done, so will have to explore how to do that. Currently i have the page out connected to a whole house system, so am not sure if that would be different.