asbril Posted August 22, 2021 Posted August 22, 2021 (edited) Is anyone using the GE Enbrighten Zwave Smart Motion Switch ? I'd like to know whether it is programmable through ISY to activate/de-activate both the light load and the motion sensor. In principle, I would expect that this switch creates separate nodes for the light and the sensor, but I'd just would like know if someone has experience with this switch. Edited August 22, 2021 by asbril
Bumbershoot Posted August 25, 2021 Posted August 25, 2021 On 8/22/2021 at 12:49 PM, asbril said: Is anyone using the GE Enbrighten Zwave Smart Motion Switch ? I'd like to know whether it is programmable through ISY to activate/de-activate both the light load and the motion sensor. In principle, I would expect that this switch creates separate nodes for the light and the sensor, but I'd just would like know if someone has experience with this switch. I just saw this, but have a look here:
asbril Posted August 25, 2021 Author Posted August 25, 2021 34 minutes ago, Bumbershoot said: I just saw this, but have a look here: Thanks @Bumbershoot I installed the switch. I changed the settings to manual in order to program the switch with my ISY and that works in principle. However, so far since yesterday, I am not impressed and my existing separate motion sensor does a better job.
Bumbershoot Posted August 25, 2021 Posted August 25, 2021 54 minutes ago, asbril said: Thanks @Bumbershoot I installed the switch. I changed the settings to manual in order to program the switch with my ISY and that works in principle. However, so far since yesterday, I am not impressed and my existing separate motion sensor does a better job. I guess YMMV. I have the motion set to "high sensitivity" and they work reliably and quickly, better than my Aeotec multi sensors. I don't see any use for the "medium" or "low" sensitivity settings.
asbril Posted August 25, 2021 Author Posted August 25, 2021 43 minutes ago, Bumbershoot said: I guess YMMV. I have the motion set to "high sensitivity" and they work reliably and quickly, better than my Aeotec multi sensors. I don't see any use for the "medium" or "low" sensitivity settings. Can you tell me how to change the settings to high sensitivity . If not I'll look it up. I am in a lazy mood today
Bumbershoot Posted August 25, 2021 Posted August 25, 2021 Just now, asbril said: Can you tell me how to change the settings to high sensitivity . If not I'll look it up. I am in a lazy mood today Press and hold the bottom button until the LED flashes once. If it flashes twice or three times, then you've set it to medium or low. 1
Recommended Posts