jpoje Posted March 9, 2022 Posted March 9, 2022 I have recently purchased several HomeSeer ZWave Sensors, which seem to all work great. The Flex Sensor has a temperature sensor and shows temperature in Celsius in Admin Console. If I do a query on it, it changes to Fahrenheit, but then quickly changes back to Celsius. I contacted HomeSeer support to see if there was a parameter I could change that would keep it at Fahrenheit and they said no and suggested I contact UD. So does anyone know how I can change this sensor to always read in Fahrenheit instead of Celsius in Admin Console? I have a thermostat and it always reads in Fahrenheit in the Admin Console. Thanks for any suggestions.
lilyoyo1 Posted March 9, 2022 Posted March 9, 2022 20 minutes ago, jpoje said: I have recently purchased several HomeSeer ZWave Sensors, which seem to all work great. The Flex Sensor has a temperature sensor and shows temperature in Celsius in Admin Console. If I do a query on it, it changes to Fahrenheit, but then quickly changes back to Celsius. I contacted HomeSeer support to see if there was a parameter I could change that would keep it at Fahrenheit and they said no and suggested I contact UD. So does anyone know how I can change this sensor to always read in Fahrenheit instead of Celsius in Admin Console? I have a thermostat and it always reads in Fahrenheit in the Admin Console. Thanks for any suggestions. What's your firmware and UI?
lilyoyo1 Posted March 10, 2022 Posted March 10, 2022 1 hour ago, jpoje said: Both are 5.3.0 Do you have the 500 or 300 zwave board
jpoje Posted March 10, 2022 Author Posted March 10, 2022 I cannot find what board it is in Admin Console or website. In Admin Console the ZWave version is 6.82.01. The model is ISY994i ZW+/IR PRO - ZWave Plus Certified, purchased May 2021.
lilyoyo1 Posted March 10, 2022 Posted March 10, 2022 (edited) 2 hours ago, jpoje said: I cannot find what board it is in Admin Console or website. In Admin Console the ZWave version is 6.82.01. The model is ISY994i ZW+/IR PRO - ZWave Plus Certified, purchased May 2021. It's the 500 board. I'd upgrade to the most recent firmware (5.4.3) found in the current release and beta sub-forum. If it doesn't show up properly there, submit a ticket Edited March 10, 2022 by lilyoyo1
Recommended Posts