I was swapping out the buttons on my 6button keypad and must have accidently pushed the set button and some other button that messed up my led settings. now when i turn the load off, the off button does not illuminate. how do i get that back? I can turn the off settings to 1 in isy and verify that all the led's do work but it used to be on15 off0 and still the off button would be illuminated like it was in an led on state.

Does it seem like it’s programmed as an 8-button controller?

not sure if below will format correctly (I’m on a mobile device) if it doesn’t see page 17 of this pdf: http://cache.insteon.com/pdf/2486D.pdf

Changing Between 6 and 8 Button Configurations
 Changing to 6-Button Configuration
 1)
body by aligning the tabs and snapping into place 2)
Attach the change-out plate to the switch
3) 4)
5)
1)
KeypadLinc will (Beep)
KeypadLinc is now in 6 Button Mode
Replace the 8-button plate with the 6-button plate -
 Gently pull the Set button out as far as it will go
 Wait 10 seconds
 While simultaneously holding the On and Off buttons, carefully push the Set button back in, flush
 with the trim frame
 Once the Set button is pushed in, continue holding the On and Off buttons for 3 seconds, and
 then release
 Changing to 8-Button Configuration
 Replace the 6-button plate with the 8-button plate -
 body by aligning the tabs and snapping into place 2)
Attach the change-out plate to the switch
3) 4)
5)
Gently pull the Set button out as far as it will go
 Wait 10 seconds
 While simultaneously holding the On/Off (upper left-most) button and the H button, carefully press
 the Set button back in flush with the trim frame
 Once the Set button is pushed in, continue holding the On/Off button and H buttons for 3
 seconds, and then release
 KeypadLinc will (Beep)
KeypadLinc is now in 8 Button Mode

I just restored the device from isy and that seemed to fix it. whew.