Did anyone succeed in getting the Zooz zse40 sensor to work with ZMatter on eisy ?

It’s mostly working now on Polisy 5.5.4. See below from another post
 

Upgraded Polisy IoX from 5.5.3 to 5.5.4
Upgrade went smoothly but, I get 5 beeps plus 1 when it finishes.

These reported issues still remain.
ZSE40 ZooZ 4-in-1 Sensor

• Will not complete interview. tried Update with Interview many times and exclude/include. ZooZ states to press z-wave button every 15 seconds for 2 minutes during include, this still didn't help.
• Not sure if this is new but: Temperature will not display in Fahrenheit only Celsius regardless of configuration parameter.

ZSE42 ZooZ Water Leak Sensor

• Cannot Query or Set Configuration Parameters

These reported issues have been fixed:
ZSE40 ZooZ 4-in-1 Sensor

• Motion Sensor node Status now changes with motion detection.
• Configuration Parameters will Query and Set

ZSE42 ZooZ Water Leak Sensor

• Leak Detected Alarm node now triggers ON and OFF with water detection.

 

6 minutes ago, vbphil said:

ZSE40 ZooZ 4-in-1 Sensor

• Motion Sensor node Status now changes with motion detection.
• Configuration Parameters will Query and Set

Thanks. I included/excluded several times but only got one single node with empty status. I'll try again tomorrow. No parameters, no query.

Edited January 22, 20232 yr by asbril