asbril Posted January 22, 2023 Posted January 22, 2023 Did anyone succeed in getting the Zooz zse40 sensor to work with ZMatter on eisy ?
vbPhil Posted January 22, 2023 Posted January 22, 2023 It’s mostly working now on Polisy 5.5.4. See below from another post Upgraded Polisy IoX from 5.5.3 to 5.5.4 Upgrade went smoothly but, I get 5 beeps plus 1 when it finishes. These reported issues still remain.ZSE40 ZooZ 4-in-1 Sensor Will not complete interview. tried Update with Interview many times and exclude/include. ZooZ states to press z-wave button every 15 seconds for 2 minutes during include, this still didn't help. Not sure if this is new but: Temperature will not display in Fahrenheit only Celsius regardless of configuration parameter. ZSE42 ZooZ Water Leak Sensor Cannot Query or Set Configuration Parameters These reported issues have been fixed:ZSE40 ZooZ 4-in-1 Sensor Motion Sensor node Status now changes with motion detection. Configuration Parameters will Query and Set ZSE42 ZooZ Water Leak Sensor Leak Detected Alarm node now triggers ON and OFF with water detection.
asbril Posted January 22, 2023 Author Posted January 22, 2023 (edited) 6 minutes ago, vbphil said: ZSE40 ZooZ 4-in-1 Sensor Motion Sensor node Status now changes with motion detection. Configuration Parameters will Query and Set Thanks. I included/excluded several times but only got one single node with empty status. I'll try again tomorrow. No parameters, no query. Edited January 22, 2023 by asbril
Recommended Posts