I connected my Webcontrol board to my ISY in the past. I now have an eISY and cannot connect to it. I understand that the ISY board needs to be on port 80 (

) but the eISY apparently does not allow to change the port (8080). Any idea about a solution?

Add the port number to the IP address like this.

 192.168.0.165:8080  I do not have a WC8 board anymore so I cannot verify this.

It does work.

But in the Network Setup, the HTTP Port needs to remain 80.

Don't ask me why, it's all above my head.

Thanks, Larry!

RV

7 hours ago, hchain said:

It does work.

But in the Network Setup, the HTTP Port needs to remain 80.

Don't ask me why, it's all above my head.

Thanks, Larry!

RV

Port 80 is always assumed by drivers when you do not specify, so maybe the drivers see the 80 and don't specify a port to conflict with the 8080 that they didn't know wasn't part of the IP address???