trevorst Posted September 27, 2023 Share Posted September 27, 2023 (edited) Just installed a new ZEN72 switch to replace a GE switch that had quit sending status but still worked from and responded to Polisy control. The new Zooz switch is exhibiting the exact same behavior, will not send any reporting from switch but is totally controllable from Polisy. Have re-interviewed the switch several times, also deleted and reinstalled the GE switch before I replaced it all to no avail. Has anyone any thoughts on this. Update: I have made some progress, there is a parameter that allows programming the scene capability, turning this on started don/dof commands being reported. Issue is they are not being sent in the main light but on the basic control. So status is not being shown on isy main switch screen. I can use the basic control don/dof to launch macros but nothing else. Edited September 27, 2023 by trevorst Link to comment Share on other sites More sharing options...
Recommended Posts