tmorse305 Posted June 13 Posted June 13 Hi @Goose66 I've been using Nodelink to interface to my alarm panel. I noticed that ioguy's website is gone so I'm thinking it might be time to move on. Does your NS allow for control of the output pins? Based on what I read I don't think so but I wanted to confirm with you. Thank you.
Goose66 Posted June 13 Posted June 13 The DSC version of the EnvisaLink plugin does have output (command output) nodes, but this was never added to Evisalink-HW. IIRC it is because the EnvisaLink HW API didn’t support it, but I can look into it. If NodeLink was doing it, then it should be accessible.
Goose66 Posted June 13 Posted June 13 I just notice that, while this was posted in the Envisalink-HW forum, the title of the topic "DSC outputs." If you do in fact have a DSC panel with an Envisalink, then the answer is yes, the command outputs will work. Here is the Envsialink-DSC forum: https://forum.universal-devices.com/forum/340-envisalink-dsc/. If you have a Honeywell Vista panel instead, then I can add triggering outputs on and off in a future version. Whether or not I will be able to display the status of the output, though, is another question, and probably one I won't be able to determine (or add support for) because I do not have a relay board in my system.
tmorse305 Posted June 13 Author Posted June 13 Thanks @Goose66, sorry I didn't realize there were 2 forums for the Envisalink NS. Yes I have a DSC panel so it's sounds like I'm good to go.
Recommended Posts