Just installed the new eisy home r2 with a few issues but working through them.

I have managed to import all my information from my 994i Administrative Console into the new eisy, now trying to work through the issues of the eisy-ui web interface. All my modules and programs show up in the Administrative Console same as before and pass function test turning light on and off. When I checked the automation section of the eisy-ui page it will list my programs but clicking on integer variable or state variable returns an Internal Server Error. I cannot "add" any variables, just get the error. Also, now that the eisy-ui is installed but not working, none of my programs are working.

How do I get past the internal server error?

First thing I’d try is a full reboot.

Tried going into the Administrative Console and in the Programs section for variables clicked on "add" for State and Integer to add a couple variables each. Had to unplug the eisy as reboot wasn't. After the reboot the eisy-ui shows the variables but I don't actually have any data applied. My programs now show the "If" and "Then" conditions set up in Ad Console.

Have to admit, creating programs in Ad Console where much easier using the available conditions, I don't see anything like that in eisy-ui. Also have no clue how to utilize the variable in eisy-ui compared to Ad Console. Looks like another rabbit hole to go down to learn how to make those work.

At this point the web ui is still a work in progress. I use good old AC to maintain and add stuff to the eISY.