apostolakisl Posted December 9, 2010 Posted December 9, 2010 After having replaced a ton of switches because of failed paddles my system became less stable. I speculated that there were some errors on devices and since I had replaced about half of my stuff, I decided to just go through and factory reset every single device and run a restore. So, yesterday I did that. During the restore, the ISY java console went dead. Needless to say, I had great anxiety during the 2 hours it took to complete the restore wondering if I had just completely scrambled my whole installation. The only comfort I had was that the PLM was blinking activity and the ISY tx/rx lights were blinking. After about 2 hours the console responded again and my system is working well. During the restore, what I had was the java console displaying like normal but not following commands. It would move from screen to screen and show devices I would click on, but if you tried to do a command, notta. It also did not indicate that any activity was going on. I closed the java console and tried to reopen, but the ISY wouldn't respond at all. The "finder" would find nothing. Question, is this normal? I would have expected to see it running down the devices with the write commands as it progressed.
Recommended Posts