I’m running 2.8.16.

 

I inadvertently clicked an icon (no idea which one) and got a “linking in progress†screen with three options and a “Finish†button. Tried to close the screen via “X†but nothing, never pushed “Finishâ€. Appeared to be locked there with no way out. Closed down explorer and tried to go back into the isy.

 

I keep getting a “Discovering nodes; retry†error, goes away in a couple of seconds, the “linking in progress†screen flashes up and then it goes to a blank explorer screen.

 

There appears to be no traffic on the network, just a power light on the isy, no flickering on any modules.

 

Anyone with any thoughts?

You clicked on the Start Linking Icon. This is the function where devices are being added to the ISY by using the Set button on the device to notify the ISY of its existence. The correct way to get out of that is to click Finish.

 

Go to Configuration and reboot the ISY (Reboot button in System section). It may be necessary to Reboot more than once. If the Configuration tab is not displayed or cannot be reached power cycle the ISY again.

Lee,

 

Many thanks again!

 

My last resort was going to be a power down. It did the trick.