ergodic Posted December 12, 2011 Posted December 12, 2011 I had a situation today where none of the motion sensors were signaling status to the ISY. I couldn't see any problem with the ISY itself so I just went down and unplugged the 2413S and plugged it back in. And things all started working again. I've had a couple of PLM failures in the past that required replacement. But I've never seen one lock up like this, or at least that's the only explanation I can see. Does that happen? Is there any experience to say it's getting ready to fail? I did note when I unplugged it that the (normally white) LED flashed red very briefly, which I've never seen a PLM do before.
Michel Kohanim Posted December 12, 2011 Posted December 12, 2011 Hello ergodic, Please see this post: viewtopic.php?f=27&t=7471 In some cases, also, we have seen that factory resetting the PLM simply causes it to go to a mode where each command just causes it to sound a long beep. With kind regards, Michel
ergodic Posted December 12, 2011 Author Posted December 12, 2011 Thanks Michael. I'll watch that thread for a resolution. I'm hoping I won't have to get yet another PLM (not to mention the spare one I keep.) For now I've moved the PLM on to the power strips controlled by the big red power button that I've told my wife to press when things don't work.
Recommended Posts