hagak Posted April 28, 2012 Share Posted April 28, 2012 I have 2 2420M rev2.2 that I linked to isy. The both seem to detect motion just fine however the Dusk/Dawn sensor never seems to get any value. The value is blank, ie not On or Off. Even after sitting in a draw for 20 min., or sitting under a lamp for 20 min. Using isy 3.2.4 Link to comment
Michel Kohanim Posted April 29, 2012 Share Posted April 29, 2012 Hello hagak, Apart from changing the sensitivity threshold, the few last times that this problem was reported it turned to be a defective unit. With kind regards, Michel Link to comment
andyf0 Posted April 29, 2012 Share Posted April 29, 2012 It should also be noted that the Dusk/Dawn message is not sent while the motion sensor is ON. So if you had a timeout set for 1 hour, sticking it in a draw for 20 mins would not cause Dusk/Dawn to be set. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.