kjbbasic Posted July 7, 2012 Posted July 7, 2012 I just purchased a ISY-994i Pro and was looking to use a 16GB micro SD card. With the card it came with I can login/set things up plus can telnet to the unit (so all looks fine). If I replace the card with the 16GB card I get the red error light plus can not telnet to the unit (cannot connect error/times out). This is the same behavior I see with 2 different 16GB cards I have. If I put the original card back in then things work fine. I'm running the latest firmware 3.2.6 (as reported by the ve command with the original card in). Any thoughts? BTW, not sure I really need the 16GB but I had the cards... ...should have added that I tried resetting the ISY unit as well...no luck.
Brian H Posted July 7, 2012 Posted July 7, 2012 You didn't mention if you had found the information on SD cards in the wiki. If not here is the link. http://www.universal-devices.com/mwiki/ ... an_SD_Card
kjbbasic Posted July 7, 2012 Author Posted July 7, 2012 Yes, I read it. Two different 16GB cards give me the flashing red error (not mem plus error, just error). (tx, rx, and power lights are blue) The original card works fine I can telnet to the unit and login....just not with the "new" cards. The error I see with the 16GB units is: Connecting to...Could not open connection to the host...connect failed... It looks like it's not seeing the unit on the net. Why would it work the the original card and not with the new cards? Direct LAN connection, no firewall, no antivirus. It's almost as tho the original SD card has some needed "base" code (or causes the unit to act differently...basic connection)...should I be able to telnet to the unit without any card present? BTW I also tried formatting the card with Fat32 and using...formatted OK but same results with ISY. Am I missing something/something basic here?
LeeG Posted July 7, 2012 Posted July 7, 2012 The SD card should be installed. Telnet to ISY to format SD card. Invoke Admin Console from UDI web site. Manually update ISY image. Which of those steps is not working and how is it failing?
LeeG Posted July 7, 2012 Posted July 7, 2012 Remember that when coming up with a new SD card the ISY and associated configuration are gone. The IP address for telnet could be different, the Admin Console must be pulled from the UDI web site because it is gone, the ISY firmware has to be reloaded because it is gone.
kjbbasic Posted July 8, 2012 Author Posted July 8, 2012 Telnet is not working with the new card(s) When I install the new card and try and telnet I get the "Connecting to [address]... Could not open connection to the host, on port 23: connect failed. The original card works fine (telnet and all else seem ok)...just swapping the card results in behavior I've described. The ISY IP address is setup to be reserved based on the ISY MAC address via DHCP. I can ping the address OK (with orig or new card installed), just not telnet with new card.
LeeG Posted July 8, 2012 Posted July 8, 2012 You are removing power and disconnecting the cables before switching SD cards.
Michel Kohanim Posted July 8, 2012 Posted July 8, 2012 Hello kjbbasic, I am so very sorry ... the current 3.2.6 firmware for 994 didn't have SDHC support turned on and thus you cannot go above and beyond 1GB. This said, this bug is already fixed and shall be included in the next drop. Again, sincere apologies. With kind regards, Michel
kjbbasic Posted July 8, 2012 Author Posted July 8, 2012 Thx! I'll await the next drop... Thx to the others that helped as well.
Recommended Posts