DevonSprings Posted December 7, 2012 Posted December 7, 2012 Hi All, I am just trying this, never tried it before. What I am trying to do is get a single click to turn on the light 70% and double click 100%. So I did this in my bathroom where I set the ON rate at 70% in the device. Then test doing on, fast on and it works perfect from the ISY. When I go to the device the ISY reports that the device is on at 70% but it is outputting 100% and so is the device. The device I am trying this with is a 2477D v.40 What am I doing wrong? Devon
Vyrolan Posted December 7, 2012 Posted December 7, 2012 When I go to the device the ISY reports that the device is on at 70% but it is outputting 100% and so is the device. Sometimes the ISY doesn't get all the info about the levels communicated to it correctly. Try setting it at the device and then on the ISY, right-click and to Query. It will actually communicate with it and ask for the level.
DevonSprings Posted December 7, 2012 Author Posted December 7, 2012 Ok that worked but I don't want to set them locally I want to set them centrally. Devon
LeeG Posted December 7, 2012 Posted December 7, 2012 What ISY firmware level? Right click bathroom switch node, select Diagnostics | Query Insteon Engine. Now set On Level (applied locally) slider to the desired value. If already set at value move it so the ISY sends a different On Level (applied locally) value. Then set it back to the value you want.
Recommended Posts