Jump to content

how do I find address of a module with out a label?


south

Recommended Posts

Initiate Start Linking, then press the ApplianceLinc Set button for 3-5 seconds. That will add the ApplianceLinc to the ISY by its Insteon Address.

 

If that does not work manually Set button link the ApplianceLinc as a Responder to a SwitchLinc (or similar device) as a Controller. Then do a Show Device Links Table for the SwitchLinc. The last active link record will normally contain the ApplianceLinc address. This must be followed by a Restore Device for the SwitchLinc to get rid of the Set button link.

 

I am not familiar with the 2002SHL3 designation. Are you certain this is an Insteon device? Could it be an X10 device.

Link to comment

2002SHL3 is an original X10 ONLY ApplianceLinc. Is a one way type. No power line transmitter in it to respond to things like a Status Request.

It is not an Insteon Module.

Your ISY controller can send X10 commands. So you maybe able to at least send it On Off and Dim commands.

Link to comment
Guest
This topic is now closed to further replies.

  • Recently Browsing

    • No registered users viewing this page.
  • Forum Statistics

    • Total Topics
      37k
    • Total Posts
      371k
×
×
  • Create New...