JimTurner

I get no errors other than a timeout on the "Test System on Remote URL". However I get the errors in the attached screen shot when doing a refresh/sync:

My issue is the same only different. I have enabled Certs through the my.isy page, and added the module through the Java front end on my PC. Trying to set this up for remote access, I see my portal with the MAC address and it shows green on the IOS app when testing the connection. However, I get a timeout and it never connects. What am I missing?

Poked around and did not find an answer. I have an ISY994 along with an Eero hub on a UPS. My issue is, I had a power failure that extended past the UPS support time. When power was finally restored, the ISY was inaccessible by any means. I am assuming it booted before the network did, and was not able to obtain a DHCP address. I unplugged the ISY and plugged it back in, and then it was addressable. I am wondering if setting a static IP in the ISY would solve this? If so, do I need to set the Subnet Mask, gateway, and DNS boxes? Eero uses 192.168.7.x IP scope. Basically I want to fully auto-recover on power restore without any manual intervention. Thanks!

Hi all, I am trapping APC UPS events to send myself emails on electrical noise, power failure and power restore. Wondered if there is a way to trigger a program on - say - electrical noise event. The program would initiate "turn off" commands on select z-wave and/or insteon devices to lessen the impact of electrical storms (that are so prevalent where I live) to expensive equipment. Thought about hitting the ISY with a URL run program command but could not find the right syntax for that. Already lost an Air Conditioner and Security camera during last storm. Thanks! ~jimt

Ok, thanks! I will check that out. Could have been named something clearer like "DeviceEvent" but I am late to the design / requirements party!

Hi all, Tried to search for this, but got nowhere. In HouseLinc (yeah, shoot me!), it would know that a device button was set from off to on or vice versa. I have not seen where or if that can be accomplished in the ISY. What I want to do is trigger a timer in a program that turns off a given Insteon device at some interval (say 2 hours) after it is manually turned on at the device itself. That possible on this platform? Thanks! jimt