cksedg

gzahar, No, they didn't match! But why? I thought they would get their commands by what was set under the name of the scene. I have them working now--THANK YOU so very much--but can you explain why/how? Thanks, Craig

I thought maybe I had a program conflicting with it, but I have disabled the only program that contains these devices--controllers and responders.

I control it with an Insteon IRLinc (2411r). I have several other scenes controlled with this unit and they all behave as they should. I have tried controlling it with a different link button on the IRLinc, but it makes no difference.

Ok, here is what I have. The devices which don't respond correctly are "Theater Closets" and "Theater Under Stairs." And I just realized that "Theater Sconces N & E" don't respond in 4.5 seconds. Thanks for your help!

Hi, I hope someone can help me. I have a scene with four devices in it. Two of the devices work as programmed; the other two go ON, even though they are set to go OFF. I have deleted the scene and the devices multiple times; but it's always the same. Two of the devices do exactly opposite of what they show in the scene. Just for kicks, I programmed the scene to turn them on, hoping it would turn them off; but of course, they went on. Other scenes using those same two devices work properly! I can't figure out where the conflict is. Thanks for any help you can give me, Craig

Just did some experimenting. I changed the wait time to one minute and everything worked correctly! I guess it takes longer than I thought to actually write the change to the module. I never would have figured it out without the "wait" suggestion, so thank you very much, gzahar!

Thanks so much for the suggestion. Unfortunately, after the 10 second wait, it just dims the lamp to 25% at the 2.0 second ramp rate. When I look at the status of the lamp module, it shows that it has changed to the 5.0 minute rate, but it still dims rapidly. You wrote "Dim" lamp device, but that only dims it one time (about three percentage points). I used "ON 25%." No luck so far! Thanks, Craig

I know similar questions to mine have been asked in this forum, but I can't figure out what I'm doing. I have a lamp which is the only device in a scene called "Lamp Scene." At a certain time of night, I want a program to change the ramp rate to 5.0 minutes and dim the lamp to 25%; then change the ramp rate back to 2.0 seconds. I have tried doing it with changing the scene ramp rate and with changing the device ramp rate; but no success. It either doesn't dim at all, or dims at the 2.0 second rate. Can someone give me the right commands to use in the program? Thanks!