SteveT

Thanks Brian , stusviews for the info. Sent from my iPhone using Tapatalk

I have the 2413s unit .. PLM green light went out, and software went into safe mode. Was wondering why a soft reboot would cause, perhaps just coincidental? Was working fine up to reboot... Sent from my iPhone using Tapatalk

Thank you all - BTW, the PLM seemed to short out after a normal reboot of the ISY from the console. I found that peculiar - I am running the ISY with a separate power supply, but the PLM can also provide POE. Am I not supposed to run this way?

Thank you stusviews - I am looking for mostly a temporary solution while i get a new PLM. Do you know if will this delete all of my insteon devices? BTW, running v.5.02 .. Thanks, Steve

I guess it was just a matter of time.. also experienced PLM failure, but i also have quite a few Z-Wave devices on my network which i expected to keep working. Seems when the ISY994 enters safe mode, it cannot do anything else? Is this by design? I would think it would work without the PLM, and eventually, as my Insteon devices fail (seem to be 2-3 years on switches, this PLM was 4 years), i will replace with something more reliable, but ISY should function.. Thank you, Steve

Thank you to everyone for your replies. Some good ideas here to consider.

I would like to connect an I/o linc to my DSC system to monitor whether or not it's alarmed or disarmed, and take action based on that status. Has anyone successfully done this, and if so, where have you connected and with what additional h/w (relay), etc. Thank you Steve Sent from my iPhone using Tapatalk

Is there a way to check the status of this open/close sensor? I am using as a water detector as well, but would like to know before the battery goes dead for example.. thanks-

On a Mac OS 10.8, java console, from the program, Details (tab), disable program doesn't seem to work. Anyone else experiencing this? Steve Update: After refreshing the console, it now shows disabled, but right-clicking and setting to disable doesn't change the program icon (to disabled).

Is there a complete list of variables (system) somewhere? I kind of guessed, and found variables like ${sys.program.#.nextrun} , ${sys.program.#.lastrun} ... Thanks, Steve