bdw72

Is FanLinc supported in the release?

I didn't know that, I will give it a shot. Thanks LeeG

If I disable Program2 then the door will not close at all, since there are no commands in Program1 to handle that. I understand that the door will stop if I open the door at the same time the hourly program is running. The hard part is handling the part where I open the garage door after dark. Right now Program2 stops the door operation becasue the criteria is being met.

The above program does not allow me to open my garage door after dark. As soon as the door starts goin up, it stops because the garage door status is open. I got to be missing something, please help.

Thanks LeeG, I will test it tonight, when I get home.

I want to shut my garage door at sunset, which it does just fine. Now I want to check that garage door every hour to see if it's open and if it is, close it. I am new to ISY-99, so any help would be appreciated. I setup a night_time variable and I use it to shut my door at night, just a fyi. Don't know what to do from here.

Thanks for the advice, and I am now able to see the status on my computer. Thanks again for the help.

Pulling the SD card and re-inserting seemed to fix it, Thank You Very Much!!!!

I installed another switch and the ISY-99i cannot find it. I connect via mobilinc and i can see the device but it does not show up on the ISY-99 admin console. Everytime I check the console it says that it is not active. Do I have a defective ISY-99?

PLM says "19.84.CD v99 /Connected"

Also the status of my one and only switch is not being shown on the Admin console.

If i click on "tools", "Diagnostics", "System status" is reports back that it is not Active

Just installed my ISY-99 and it seems to be acting up, it's always offline, I reboot it, and then it goes offline after a few minutes. Already added a switch, it took a while to finally show up in the ISY-99, now I am trying to install a Fanlinc module and it;s just not showing up. Help!!

it's finally working, many reboots, now everything appears fine

I have tried it both ways, and nothing shows up. I have looked at my ISY-99 and there are no lights flashing at all. Just the power light is on steady.

I just purchased an ISY-99i and PLM, plugged them in and configured them. I logged into the ISY-99 no issues. I just installed my first switch, 2477D, but i cannot get it to show up in the ISY-99. I currently am an x10 user and I want to move to Insteon. I pushed the set button on the switch and clicked on the start linking buttonin the ISY-99 and nothing appears. Any help would be greatly appreciated.