RLIKWARTZ

Ok, I tried a restore again and everything is fine. Don't know what happened.

Ok, thank you. Maybe I'll try it again.

Has anyone tried to restore from a backup made by 3.2.1? I tried just recently and it had thrown away devices and device folders and put some scenes at the end of the tree and removed them from their folders. I had to go back to 3.1.17 and restore and then upgrade back to 3.2.1 and everything was fine. I've not tried it again to see if it was a fluke. I just thought I would check with others.

Using one of those links did it now everything looks good. Thank you.

Same with me. I didn't have to restore the config the programs were back after going back to 3.1.17.

Didn't work. I'm going back.

Same thing happened to me. I'm doing a restore now to see if everything comes back.

It look like in the documentation that there was some kind of control involved using insteon. I understand the actual viewing might be through a viewer, but couldn't the control be done through the isy?

Do you plan to some how integrate the new ip camera from Smarthome into ISY-99i?

Thank you. I'll check into it then. Thanks.

I have the current firmware version loaded. Now a kind of side question is I have a older ISY99. I've not checked the SD size. Can the amount of free space on the SD card affect the general responsiveness of the ISY to responding to events that driving programs or devices that are directly linked to each other? In other words can it slow things down?

Thank you. I had them removed from the scene before and didn't remove them from the scene this time and was surprised when they responded. They were for Christmas lights and I only use them this time of year.

I have some devices disabled in a scene. When the scene is turned on or off the devices still respond. Is this working correctly?

Upgrade went smooth.

I've seen the same problem with the floor plan even though I don't regularly use the floor plan.

Ok, on a lark I removed the switch from the ISY, factory reset the keypad added it back in and now when I control the scene the indicators go off and on as they should. Go figure everything works now. Thanks for responding.

I have a scene set up that uses a button on the keypad to swich a recepticle on or off. When it it's on the indicator light in the button lights. Now I want to be able to turn the scene off from a program and have the button light go off. I've tried turning the scene off, but that has no affect on the button light. It stays lit. Is there any way to turn the button light off from a program?

As a follow up. I was thinking and just on a lark I went out and change the wait interval, update and changed it back and updated it and then saved the program and the program now seems to be working correctly again.

I'm using the dawn/dusk control from a motion sensor to trigger the program.

I think someone else may have reported this. I have a program that is triggered at dawn. It runs the first so many steps because things happen like I would expect i.e. lights going off. It then runs into a wait and it never gets past that wait because the other events never happen. The other interesting thing is in the summary it looks like it never ran. There isn't a a start time or end time. This worked until 3.1.1 and broke after that I think.

Do you know when you might be also work on the wild card years so an event can be set to run every year without changing it each year.

I tried something on a lark. I updated the disable problem line so it was the same except updated and then saved the program and it started working.

I've notice something not working and I'm not sure when it stopped working. I have a program that disables itself as the final step and it no longer seems to be able to disable itself.

Update good.

Updated from .14 to .15 and all is well.