Hello!

 

I use an EZIO4O to trigger my garage doors, but the device comes by default set to Latching mode for the Relay, and so that means I have to send an On, wait 2 sec, and send an Off.

 

Normally I wouldn't care too much about that, but the devices in my garage seem to not communicate very well with the rest of the house (it's a very long run of cable, and my Access Points seem to barely make up the difference), so I don't want them to be stuck "on" ever.

 

The EZIO4O can be programmed to be Momentary, but the programming software requires me to connect my laptop directly to the PLM, and I don't even have a COM port on my laptop, so I'll have to go find a USB-to-Serial adapter... etc...

 

So, my question is:

Is there any hope to get an [OPTIONS] button for the EZIO4O in the ISY admin console? (similar to the one for the IOLinc)

 

I realize the EZIO4O is not actually produced by SmartHome (rather by "Smartenit"), but I had assumed there would be a way for the ISY to tell the PLM what to do to program it... perhaps not...

 

-Taner

Hi Taner,

 

Unfortunately we do not have any plans for those options in Admin Console.

 

With kind regards,

Michel

Unfortunately we do not have any plans for those options in Admin Console.

Ahh, bummer...

 

Well, I had been thinking to re-do all the wiring to use the Relay side of the IOLincs I have monitoring the doors... it will just be a lot more/extra wiring. Ahh well

 

Thanks again,

 

-Taner