I have configured an 8 button RemoteLinc 2 to open my garage door. Configured as 8 scene non-toggle. At present, only configured button A to the Garage door. Sometimes, if I press button A to open or close the door, after about 2-3 seconds, the door will stop opening or closing and reverse operation. Not sure why this is happening? Is the RemoteLinc 2 sending multiple on commands to the Door relay?

This could depend on how you relate the remotelinc to the garage door. Is it via a scene? A program? Both? I do not expect that the remotelinc to be sending multiple commands.

 

It could also be unrelated. Perhaps there is something that suddenly blocks your safety sensors. Perhaps there is some binding in the door motion. If this happens when the door is opening as well as closing, I would tend to discount this possible cause.