jmed999 Posted December 17, 2014 Posted December 17, 2014 I have a wireless thermostat that has been used for several months wirelessly and has always worked great when providing the temp to the ISY/mobilinc, etc. I have it placed in a foyer gable area to provide the temp up there and programed to control a fan to recirculate the heat. Recently I had to replace my PLM and when I got around to restoring the stat the batteries were dead. I replaced the batteries and restored the stat. It is communicating with the ISY according to the event viewer. The problem is the temp doesn't show up in the admin console. I've tried everything to get the temp to show with no luck. Current State, Setpoint and Humidity are all blank. Any suggestions on how to get it working again? It isn't and never has been plugged in to AC power. Thanks!
Techman Posted December 17, 2014 Posted December 17, 2014 Try a factory reset on the thermostat, it's possible something in its memory got corrupted.
stusviews Posted March 2, 2016 Posted March 2, 2016 I'm having same issue, how did you resolve it? Which specific thermostat?
barkster Posted March 2, 2016 Posted March 2, 2016 (edited) 2441ZTH - i've read that it won't send status until a 2 degree temperature change. I would have imagined by now I would have had a 2 degree change. I'm going to test that tonight. Edited March 2, 2016 by barkster
stusviews Posted March 2, 2016 Posted March 2, 2016 What is the result if you put the thermostat into linking mode?
barkster Posted March 3, 2016 Posted March 3, 2016 (edited) I've relinked it, I've reset it, I've tried everything. The temp on thermostat shows correctly, it's just not reporting back. I even got in my hot tub and the temp changed 14 degrees so I know it's not that. Man everything worked so good before I lost my plm. I was going to remove it completely from the isy next and re add it. I don't use it anywhere other than checking temp of hottub. Edited March 3, 2016 by barkster
Recommended Posts