nasa01 Posted February 23, 2015 Posted February 23, 2015 Hi, I have a relay attached to a z-wave controlled outlet that I have used to open/close my garage doors. Simply put, I have the outlet turn on for 5 seconds then turn off (which simulates pressing the door opener). I am unsure of how to do that with my ISY. Any hints? Thanks in advance,
Xathros Posted February 23, 2015 Posted February 23, 2015 If <whatever your conditions> Then Set 'ZWave Outlet' On Wit 5 Seconds Set 'ZWave Outlet' Off Else Should be all it takes. Unlike the IOLinc, this solution offers no feedback as to the status of the door. Do you have some way to verify that the door is open or closed? -Xathros
nasa01 Posted February 23, 2015 Author Posted February 23, 2015 Hey Xathros, Thanks for the solution (not sure why I missed that). I am actually using IOLINC to tell me the state of the garage doors (yes, a mixing of z-wave and INSTEON is going on here). Since my garage door opener has controls for locking out/ lights/ and opening - I kept the working relay setup. Nathan
Xathros Posted February 23, 2015 Posted February 23, 2015 Hi Nathan- Sounds good. Glad I could be of assistance. -Xathros
Recommended Posts
Archived
This topic is now archived and is closed to further replies.