bcsh Posted May 15, 2015 Posted May 15, 2015 I have a motion sensor setup in a bathroom and when I had it setup with the Insteon hub it seemed a lot faster then now being setup with the isy. I have a program setup for the light to come on. Is there a different way I can set this up to make the light respond faster? If From 5:30:01AM To 10:29:59PM (same day) And Control 'Motion Sensor-Sensor' is switched On Then Set Scene 'Light Bulb Scene (day)' On Wait 3 minutes Set Scene 'Light Bulb Scene (day)' Off Else Set 'Bathroom Strip Light' 20% Wait 2 minutes Set 'Bathroom Strip Light' Off Thanks!
stusviews Posted May 15, 2015 Posted May 15, 2015 The Hub created a scene which is way faster than a program. You can create an ISY scene between the MS and the devices in the Light Bulb scene and it'll be faster, but you lose the ability to schedule the light.
chrishick Posted May 15, 2015 Posted May 15, 2015 You can put the MS and light together in a scene and then adjust the on level of the scene using a program.
larryllix Posted May 15, 2015 Posted May 15, 2015 (edited) After creating the scene and installing it into your MS using the linking mode this should work for you. We don't even detect any light on delay with this technique. Here is the programs I use for my bedroom lamp: MBR Lamp.auto - [iD 009D][Parent 000A] If Control 'Master Bedroom / Motion.MBR' is switched OnThen Wait 45 seconds <---------------------------------note the On is via scene direct control and not needed here. Set Scene 'Master Bedroom / MBR Passtrough' Off Run Program 'MBR Lamp.auto' (Else Path) <------------makes state visible from folder colourElse - No Actions - (To add one, press 'Action') ------------------- Now to adjust the response of the lamp I use this two time node program: MBR Lamp Level adjust - [iD 0084][Parent 000A] If From 10:30:00PM To 9:30:00AM (next day)Then In Scene 'Master Bedroom / Motion.MBR' Set 'Master Bedroom / MBR Wall Lamp' 15% (On Level) ^------Note to select the MS as the scene, NOT the lamp!!!Else In Scene 'Master Bedroom / Motion.MBR' Set 'Master Bedroom / MBR Wall Lamp' 70% (On Level) ---------------------- Of further interest may be this manual override program operated by a remote keypad: MBR Lamp.manual - [iD 0038][Parent 000A] If Control 'Master Bedroom / MBR KeyPad.A' is switched On And Control 'Master Bedroom / MBR KeyPad.A' is not switched OffThen Set 'Master Bedroom / MBR Wall Lamp' Fast On Disable Program 'MBR Lamp.auto' Disable Program 'MBR Lamp Level adjust' In Scene 'Master Bedroom / Motion.MBR' Set 'Master Bedroom / MBR Wall Lamp' 100% (On Level) Wait 2 hours Run Program 'MBR Lamp.manual' (Else Path)Else Set 'Master Bedroom / MBR Wall Lamp' Off Run Program 'MBR Lamp Level adjust' (If) Wait 1 second Enable Program 'MBR Lamp Level adjust' Enable Program 'MBR Lamp.auto'Lamp will get direct hit by MS so adjusted scene level. Edited March 20, 2016 by larryllix
Recommended Posts