Jump to content

ZWave Controls in Scene


Recommended Posts

A newbie to ZWave with some new controls for my kitchen.  They are Kichler dimmers for LED under cabinet lighting.  I can add them just fine into ISY.  I can manipulate them directly from the console, turning them on, off, dim up, dim down, etc.  I can drag them into my existing scenes that are made up of all Insteon controls and see them in the tree to the left.  However, when I click on the scene name or any of the controllers in the scene, the ZWave controls do not show up to configure.  I upgraded the firmware, but I still don't see them.

 

I've only been able to get them to work with my Insteon controls by creating programs.

 

Any help?

Link to comment
Share on other sites

my experience (only a small number of z-wave devices) is that z-wave devices work in scenes as responders (no doubt with assist from the ISY), but do not behave as scene controllers.  Also, when using z-wave devices as program triggers, only STATUS works, not CONTROL.  Perhaps there are differences between z-wave devices, so YMMV.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...