Fibaro Swipe

[BlackSheep]

Any chance the ISY will have support for the Fibaro Swipe?

 

I mistakenly bought one without checking whether it was supported by the ISY or not. It might have been because I foolishly didn't question their claim of "Compatible with any Z-Wave or Z-Wave+ Controller."

 

Cheers.

[stusviews]

What's the result if you try to include it? BTW, many Z-Wave devices require that you exclude it (twice) before trying to include it.

[BlackSheep]

What's the result if you try to include it? BTW, many Z-Wave devices require that you exclude it (twice) before trying to include it.

 

Hi Stu,

When I try to include the Swipe, it does appear to be included but it shows up as 'ZW024_1 - Unintialized'. Nothing else shows up under the device, but the isy does seem to register gestures from the Swipe in the Event Viewer. 

 

This is what I got when I included the Swipe after excluding it twice first as you recommended:

 

Tue 11/29/2016 08:06:01 : Listening for Z-Wave devices to remove from the network

Tue 11/29/2016 08:06:14 : Removing Z-Wave devices stopped

Tue 11/29/2016 08:06:15 : Device 23 excluded from Z-Wave network

Tue 11/29/2016 08:06:27 : Listening for Z-Wave devices to remove from the network

Tue 11/29/2016 08:06:42 : Removing Z-Wave devices stopped

Tue 11/29/2016 08:07:33 : Listening for Z-Wave devices to add to the network

Tue 11/29/2016 08:07:44 : Z-Wave device detected, retrieving info 2

Tue 11/29/2016 08:07:44 : Z-Wave device detected, retrieving info 3

Tue 11/29/2016 08:07:46 : Z-Wave device detected, retrieving info 5

Tue 11/29/2016 08:07:46 : Adding Z-Wave devices stopped

Tue 11/29/2016 08:07:47 : Exchanging data with secure Z-Wave device 24 of type 4.24.1

Tue 11/29/2016 08:07:47 : Adding secure Z-Wave device

Tue 11/29/2016 08:07:49 : Adding ISY node(s) for new Z-Wave device 24 type 4.24.1

Tue 11/29/2016 08:07:49 : [ZWAVE-ADD-NODE  ] Add device: mfg 010F.0D01.2000, basic=0x04 gen=0x18 spec=0x01

Tue 11/29/2016 08:07:49 : Adding associations for new Z-Wave device 24

Tue 11/29/2016 08:07:52 : Setting ISY as wakeup target for new Z-Wave device 24

Tue 11/29/2016 08:13:41 : [ZWAVE-WAKEUP  13] Awake with no pending work, put back to sleep ZW013_1

[Chris Jahn]

I think the device uses some command classes that we do not yet support, but we will support this device in 5.0.x (not sure what build though).

[BlackSheep]

Okay, thanks.