jrabin Posted February 8, 2009 Share Posted February 8, 2009 This is making me crazy. I cannot get the motion detector (2420M) to link to my ISY99. Per this forum, battery has been in way more than 5 minutes. I've tried linking by pressing the button on the back of the 2420M and putting it in link mode, and by typing it's ID in New Insteon Device. Nothing works. I know it's communicating with my Access Points, and I know the device is working because I linked it to a Lamplink 2456 and it worked. I'm running 2.6.15, and all is working fine. Just cannot link with the motion detector. Ideas? Link to comment
Sub-Routine Posted February 8, 2009 Share Posted February 8, 2009 The motion sensors cannot be linked in Auto Discover mode. Menu - Link Management/New INSTEON device Enter the address. Select the Motion Sensor from the drop down list. It's the 2nd from last device. Follow the instructions to put it in linking mode. Rand Link to comment
jrabin Posted February 9, 2009 Author Share Posted February 9, 2009 The motion sensors cannot be linked in Auto Discover mode. Menu - Link Management/New INSTEON device Enter the address. Select the Motion Sensor from the drop down list. It's the 2nd from last device. Follow the instructions to put it in linking mode. Rand Cool, it worked. Is this posted somewhere? This took forever to figure out. I tried the manual add, but didn't put the device in linking mode. Jeff Link to comment
Sub-Routine Posted February 9, 2009 Share Posted February 9, 2009 Cool, it worked. Is this posted somewhere? This took forever to figure out. I tried the manual add, but didn't put the device in linking mode. Jeff It must be, I read it somewhere I added it to the Wiki How-To as well. The programmers are adding features faster than I can keep up! Rand Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.