born2dive Posted August 21, 2018 Posted August 21, 2018 Is there a way to enable and disable ISY devices, remotely while I am away, using a program? Reading through the forum, I guess one way is to use variable and use it as a proxy for the device but that does not really disable the device. Any thoughts or examples would be appreciated. Thanks.
rpsa Posted October 13, 2018 Posted October 13, 2018 I too would like that. I want to be able to disable some devives when I go away, but enable them just prior to my return home.
larryllix Posted October 13, 2018 Posted October 13, 2018 (edited) The usual way most conclude in the end is. - Create a State variable called $sVacation. (note: I find vacation and away to be two different scenarios needed.) - Create ways to control the variable accurately when you are away from home. I use my $sAway variable with a 16 hour delay to automatically set the house into Vacation mode, as well as a few manual methods. - Use the variable to control key programs, disallowing them to run in the "If" section, or control Then / Else with a different routine based on $sVacation = $cTRUE or $cFALSE Edited October 13, 2018 by larryllix 1
Recommended Posts