jmilt13 Posted December 25, 2018 Share Posted December 25, 2018 Have a new Motion Sensor II, it will connect to the insteon hub (used it to verify address was correct), will also link to a switch manually. I cannot get ISY to find it. Used the add motion sensor ii menu, nothing happens. Any ideas? Link to comment Share on other sites More sharing options...
larryllix Posted December 25, 2018 Share Posted December 25, 2018 Did you factory reset it before attempting to link it to ISY?Sent from my SM-G930W8 using Tapatalk Link to comment Share on other sites More sharing options...
Brian H Posted December 25, 2018 Share Posted December 25, 2018 What version of firmware is in your ISY994i? Full support for the Motion Sensor II was added in the Beta version 5 series of firmware. I have seen some report minimum support with 4.7.3 and calling it a Motion Sensor. Then using a HUB to adjust some of the options. You are waking it up before trying to add it. By holding the set button? Link to comment Share on other sites More sharing options...
jmilt13 Posted December 25, 2018 Author Share Posted December 25, 2018 Thanks for the replies. I gave up for an hour, came back to laptop and it was magically added. I did update to the newest alpha firmware, and the last thing I did was try adding it with Agave. No clue which method finally worked. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.