dbwarner5 Posted January 14, 2020 Share Posted January 14, 2020 @Michel Kohanim FYI, two issues.... running 5.16b, went to link a new micro dimmer, linking screen came up with the FINISH on the bottom, but immediately, a "linking" progress bar showed up and then.... nothing.. The linking progress bar ran over and over, very slowly. Finally after 30 minutes, I rebooted the isy. When it came back up, same result plus nothing populated. The linking progress bar came up by itself. This time, I left for some errands. It ran for over 2 hours, with one step progress into the second potential issue, getting the Elk Topography. First problem seems to be resolved with an unplug and replug of the isy, however the elk topography I have noticed seems to take 5-10 minutes upon every few Admin Console loads. Is this normal? screen shots fyi. thanks. First screen shot of first problem, fyi, Second screen shot is after the unplug, showing a 5 minute length of time for the elk topography. Link to comment Share on other sites More sharing options...
lilyoyo1 Posted January 14, 2020 Share Posted January 14, 2020 Did you put the device in linking mode? Link to comment Share on other sites More sharing options...
dbwarner5 Posted January 14, 2020 Author Share Posted January 14, 2020 Yes of cours.. but as I said, it jumped a step vs what you usually see... usually you click finish and it starts the lining process.. I didn’t even get that chance, it just jumped into linking mode and got stuck. Link to comment Share on other sites More sharing options...
dbwarner5 Posted January 14, 2020 Author Share Posted January 14, 2020 It is just coming back up now fully. After it calms down, I am going to try again. Link to comment Share on other sites More sharing options...
dbwarner5 Posted January 14, 2020 Author Share Posted January 14, 2020 worked this time as expected... strange. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.