Having Problems Connecting Leviton Switch

[NFMMALICE]

 

I'm trying to add a Leviton Switch and an Ecolink Z WAve Pir Motion Sensor...  My ISY994izw Finds the Ecolink Motion Sensor just fine, but refuses to find the Leviton Z Wave Switch.  They are within 2 Feet of each other.

 

The Ecolink is Battery operated, and the Leviton is Hard wired, so I'm not entirely sure where the failure is.

 

 

[dbuss]

If you haven't already, try excluding the switch and then try adding it.

Sent from my SM-N950U using Tapatalk

[NFMMALICE]

How do I exclude the switch?

 

[NFMMALICE]

The switch has never appeared on the Universal Devices admin console.  When I put it into pairing mode, it fails to find it.  It CAN find the Switch that is sitting 2 feet above it, though.. lol

[oberkc]

Does the leviton switch have a means to reset it to factory default settings?  I cannot help but suspect it may already think it is part of a zwave network.

 

[lilyoyo1]

What's your isy firmware and UI? You must be on the latest for it to work with leviton

[DrLumen]

I just happen to have a Leviton Z-Wave dimmer install sheet handy.

To exclude, hold the top paddle for 7 seconds. The LED should flash amber. Start exclude from the ISY and then tap the top paddle once. The led should flash green once.

To reset a Leviton Z-Wave dimmer to factory default hold the top of the paddle for 14 seconds. The LED should flash amber/red. Release the paddle and the dimmer/switch resets.

As to latest version, they would work on the 4.0+ release but not well. The dimmers were recognized and operable but the ISY did not recognize Hails so the ISY was not updated from on/off/dim actions at the switch.