Has anyone else noticed the rapid blinking of the LED on the 2420M motion sensor after detection. I know it means it has not received acknowledgment from a linked device. However my MS will randomly flash after detection. Whether it flashes or not the scene or linked device or program linked to it will always turn on or run. And it doesn’t happen all the time, just sometimes.

 

All of my MS’s will randomly flash after detection, there doesn’t seem to be any rhyme or reason to the occurrence

 

I was just wondering if anyone else has noticed it in their systems.

 

All my MS’s are v1.1

 

Thanks,

 

Tim

Hi Tim,

 

You have gotten it correctly: one or more of the members of the scene for which your MS is the controller is not sending an ACK.

 

I recommend the following:

1. Bring the Access Point closer to your MS

2. Restore responders in the scene one at a time and test

 

With kind regards,

Michel

 

Has anyone else noticed the rapid blinking of the LED on the 2420M motion sensor after detection. I know it means it has not received acknowledgment from a linked device. However my MS will randomly flash after detection. Whether it flashes or not the scene or linked device or program linked to it will always turn on or run. And it doesn’t happen all the time, just sometimes.

 

All of my MS’s will randomly flash after detection, there doesn’t seem to be any rhyme or reason to the occurrence

 

I was just wondering if anyone else has noticed it in their systems.

 

All my MS’s are v1.1

 

Thanks,

 

Tim