Bob_the_Tinkerer Posted June 15, 2021 Posted June 15, 2021 I've just installed a Fibaro FGBS-222 to my ISY (v4.9.0, 300 series Zwave dongle) and I only see three nodes: There should be more nodes, for the various inputs and the two I/O channels. Can anyone tell me what I need to do to add the other nodes, or is this device not supported in v4.x firmware?
lilyoyo1 Posted June 15, 2021 Posted June 15, 2021 7 hours ago, Bob_the_Tinkerer said: I've just installed a Fibaro FGBS-222 to my ISY (v4.9.0, 300 series Zwave dongle) and I only see three nodes: There should be more nodes, for the various inputs and the two I/O channels. Can anyone tell me what I need to do to add the other nodes, or is this device not supported in v4.x firmware? Most likely not supported since multi channel is not supported in 4.x. You'll need to upgrade to 5.0.16c. make sure that you READ THE INSTRUCTIONS COMPLETELY, if/when you do 1
Bob_the_Tinkerer Posted June 18, 2021 Author Posted June 18, 2021 Thanks. I was afraid of that, since I was hoping to avoid having to upgrade my zwave dongle, but I guess I'll have to bite the bullet.
xlurkr Posted June 18, 2021 Posted June 18, 2021 You don't need to upgrade the dongle to run 5.0.16C. That's the last release that supports the original dongle. However, you may find that some of the nodes still won't work after showing up. This is device-dependent. I have a couple of ZooZ switches for which that is true, and plan to upgrade the dongle and firmware to deal with it. It will cost you nothing to try 5.0.16C first, and see if it solves your problem. -Tom 1
Bob_the_Tinkerer Posted June 22, 2021 Author Posted June 22, 2021 I didn't realize that. Will try 5.0.16C asap. Thanks!
Recommended Posts