20 hours ago, Techman said:

It appears that you have the 500 series board and just need to follow the ISY firmware upgrade instructions in my earlier post.

I have inherited a 300 Zwave board. it has the LED and not sure if I want to break into Zwave yet but would like to test some things. IIRC it was v5.0.16c ?
Do you remember the highest V5 version that can support it?

Hi, Techman.  Circling back with you on the result of my case...

Michel assisted me.  After sending him a photo of the dongle, he confirmed it is a series 500.  He had no comment on as to why it's working in a 4.6.2 system but, he did tell me I have to upgrade to 5.3.4

 

Thanks again.

 

Hi, Techman.  Circling back with you on the result of my case...

Michel assisted me.  After sending him a photo of the dongle, he confirmed it is a series 500.  He had no comment on as to why it's working in a 4.6.2 system but, he did tell me I have to upgrade to 5.3.4

 

Thanks again.

 

larryllix,

I'm not sure, you'll probably have to ask Michel. I know that the 500 series board requires a minimum of 5.2.,0 

You could try installing it with your current firmware and either it will work or not, no harm done

Edited September 13, 20214 yr by Techman

2 hours ago, cwagner2401 said:

Hi, Techman.  Circling back with you on the result of my case...

Michel assisted me.  After sending him a photo of the dongle, he confirmed it is a series 500.  He had no comment on as to why it's working in a 4.6.2 system but, he did tell me I have to upgrade to 5.3.4

 

Thanks again.

 

5.0.16c is the highest firmware that supports the 300 board. Support for the 500 series came in 5.0.13