jkraus Posted January 8, 2010 Share Posted January 8, 2010 for the first time I have an application where I want the lamps local on/off switch to control a lamp plugged into a lamplinc. I know about load sensing, but it seems to always come on at 100%. Is there a way to have it come on at what the level the lamplinc is set? Link to comment
Sub-Routine Posted January 8, 2010 Share Posted January 8, 2010 Hi Joe, I think on the LampLincs you have to reset them for the local level/rate to take effect. Unplug the LL for a few seconds. Rand Link to comment
fitzpatri8 Posted January 8, 2010 Share Posted January 8, 2010 You do that by clicking on the LampLinc in the device tree and changing the On Level (Applied Locally). Local=the settings used when the actual device button is pushed or, for plug-in modules, the controlled load is switched off then on. Link to comment
jkraus Posted January 8, 2010 Author Share Posted January 8, 2010 fitzpatri8 tried that and did not work,but as Sub-Routine says perhaps I need to power cycle the lamplinc. Will try tonight Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.