KenUD Posted February 8, 2010 Share Posted February 8, 2010 I have a whole house on scene controlled by a keypad. I am trying to add a controlinc to the scene. It starts setting up but a after a minute or so stops. How do I know what is causing the problem? Ken Link to comment Share on other sites More sharing options...
oberkc Posted February 8, 2010 Share Posted February 8, 2010 Is it possible you have communication problems? Try a scene test of your scene-in-question. Any indications of problems? Try plugging in your controlinc into the same outlet as your PLM and see if this helps. Link to comment Share on other sites More sharing options...
Michel Kohanim Posted February 9, 2010 Share Posted February 9, 2010 Hi KenUD, In addition to the recommendations by oberkc, I would also like to add the following: 1. Do a scene test on that scene (Tools | Diagnostics | Scene Test). If any devices fail this test, write down their type and version number and post here 2. You can use Event Viewer on Level 3 to see which ones are failing. In releases 2.7.10 and above, you will have an indication of which ones failed through green 0101 icons With kind regards, Michel Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.