skunkiechris Posted February 18, 2023 Posted February 18, 2023 (edited) Hi...migrating from a Polisy with the Zooz dongle to the ZMatter board. The plugged in Z-Wave devices (various) and door locks (Kwikset) worked fine. However, not a single motion sensor (Zooz ZSE-09, Dome DMMS-1) or leak detector (Ecolink FLF-ZWAVE5-ECO) would interview after many, many attempts and bringing the devices directly next to Polisy. (Operating on 5.5.6) I tried reducing speed, no help. At this point I've rolled back. Has anyone had any success with any of these devices? Any suggestions? I have 8 of those motion detectors and 3 of the leak detectors. Also I saw this asked in another post but there was no reply, is there no way to see the routing info any longer? Thanks... Edit: Realizing now that I probably should have captured ZWAY.LOG to provide here. 🤦♂️ I'll go back and do that... Edited February 18, 2023 by skunkiechris
DennisC Posted February 18, 2023 Posted February 18, 2023 12 hours ago, skunkiechris said: Hi...migrating from a Polisy with the Zooz dongle to the ZMatter board. The plugged in Z-Wave devices (various) and door locks (Kwikset) worked fine. However, not a single motion sensor (Zooz ZSE-09, Dome DMMS-1) or leak detector (Ecolink FLF-ZWAVE5-ECO) would interview after many, many attempts and bringing the devices directly next to Polisy. (Operating on 5.5.6) I tried reducing speed, no help. At this point I've rolled back. Has anyone had any success with any of these devices? Any suggestions? I have 8 of those motion detectors and 3 of the leak detectors. Also I saw this asked in another post but there was no reply, is there no way to see the routing info any longer? Thanks... Edit: Realizing now that I probably should have captured ZWAY.LOG to provide here. 🤦♂️ I'll go back and do that... Try updating to the latest version, 5.5.7 and see if that corrects your issue.
Recommended Posts