Third Reality Motion disconnects from IoX within a few hours

[TheA2Z]

First week using a zigbee device on my eisy with IoX 5.6.4.  It installed and functioned fine, but after a few hours it shows as a disconnected node and quits triggering programs.  I had another one, so I installed it.  It did the same thing.  its about 25 feet away from eisy.

Im a bit of a noob with these zigbee devices.  Anyone have any tips or tricks?  Or could it be IoX related?

 

Edited August 24, 2023 by TheA2Z

[DennisC]

I wonder if this could be related to the IoX slowdown bug that was recently discovered in 5.6.4.

There was a patch, not a version upgrade released yesterday. Did you try installing that by running package update from admin console?

[TheA2Z]

6 minutes ago, DennisC said:

I wonder if this could be related to the IoX slowdown bug that was recently discovered in 5.6.4.

There was a patch, not a version upgrade released yesterday. Did you try installing that by running package update from admin console?

@DennisC  Actually have not had a chance yet.  Will do so tonight.  Hopefully that does the trick.  I'll post back results.

[TheA2Z]

Update: it appears to updating to latest patch has fixed the third reality motion dropping off.  Its been running for a couple of days and so far, so good.  Will chime back in if it acts up again but so far so good.