GHenry Posted December 11, 2023 Posted December 11, 2023 eisy f/w 5.7.1, Z-Wave module 21075, Z-Wave “beta version” (?) I’m trying to install an Aeotec TriSensor which supports Z-Wave Plus. Installation is straightforward except for security, but I do not see any values for light, temperature, or motion…I do have two new items, ZY 001 V1 Alarm and ZY 001 Wake Up, but no readings. I know the devices work with ISY. Any insight?
Solution dbuss Posted December 11, 2023 Solution Posted December 11, 2023 38 minutes ago, GHenry said: eisy f/w 5.7.1, Z-Wave module 21075, Z-Wave “beta version” (?) I’m trying to install an Aeotec TriSensor which supports Z-Wave Plus. Installation is straightforward except for security, but I do not see any values for light, temperature, or motion…I do have two new items, ZY 001 V1 Alarm and ZY 001 Wake Up, but no readings. I know the devices work with ISY. Any insight? For what it's worth. I've experience this with a few Z-Wave devices and currently with my First Alert ZCOMBO alarms. The other devices that experienced this I was able to get all the nodes by removing and re-adding and in some cases preforming several interviews. Thus far I've been unsuccessful doing this with my First Alert alarms.
GHenry Posted December 11, 2023 Author Posted December 11, 2023 (edited) I read somewhere that eisy didn’t support S2 authentication. Anyway, when presented with the security dialog, I had to “select none,” and that caused SEVEN devices to appear: Home Security Alarm, Motion Sensor, Motion Sensor (again!), Multilevel Sensor, Wake Up, SC Basic Assoc 2, and SC Basic Assoc 3. All I wanted was the lux reading, and that’s only in “Multilevel Sensor.” Good grief! What are all those things? Can I just delete SIX of them?! Edited December 11, 2023 by GHenry
dbuss Posted December 11, 2023 Posted December 11, 2023 8 minutes ago, GHenry said: I read somewhere that eisy didn’t support S2 authentication. Anyway, when presented with the security dialog, I had to “select none,” and that caused SEVEN devices to appear: Home Security Alarm, Motion Sensor, Motion Sensor (again!), Multilevel Sensor, Wake Up, SC Basic Assoc 2, and SC Basic Assoc 3. All I wanted was the lux reading, and that’s only in “Multilevel Sensor.” Good grief! What are all those things? Can I just delete SIX of them?! if you delete them, they will most likely return. Most have a file named unused nodes and put them all in there. That way they are out of site...out of mind.
Recommended Posts