SHM Posted March 25 Posted March 25 Just added Rachio plugin to my PG3x on polisy, 3.2.20 in hopes of controlling a new rachio smart hose timer. I have an api from rachio and in the configuration page, I have set the host to either the LAN IP of the Polisy or rachio (not at the same time) and made sure there was a firewall rule on my Eero to allow port 3001. Either way, the result in AC just shows "Rachio Bridge" with 1 node server. Any suggestions? Rachio_3-24-2024_51549_PM.zip
paulbates Posted April 26 Posted April 26 (edited) Sometimes for plugins what the ac panel shows, vs what's available in program statements under status or control are different. Did you try to write a program and see what's available there? I bring it up as the ring plug-in behaves this way. Edited April 26 by paulbates
SHM Posted July 12 Author Posted July 12 Yes, tried to write a program and in THEN section, rachio plugin only shows "query"
paulbates Posted July 15 Posted July 15 That looks like the node pg3 uses for keep alive between it and the plug-in, which can be separate and have just the controller. There should be other nodes that sometimes only appear after reboot or 2 after installing the plugin. Have you rebooted it?
Recommended Posts