Yale Door Lock YRD226 Z-Wave - no user codes supported in EISY

[blaine]

I've just migrated from an ISY-994i with a 500-series z-wave card to EISY with a Z-Matter dongle. My question pertains to z-wave functionality for the Yale door lock model YRD226.

On the ISY-994i, I was able to set user codes in ISY and send out notifications for particular users (think housekeeper) upon unlocking the door. It appears that this functionality isn't supported under EISY/Z-Matter.

Is it possible to bring over the exact same functionality that was supported with the ISY-994i and series 500 z-wave card?

Thanks,
Blaine

Edited October 31 by blaine
typo

[lilyoyo1]

11 hours ago, blaine said:

I've just migrated from an ISY-994i with a 500-series z-wave card to EISY with a Z-Matter dongle. My question pertains to z-wave functionality for the Yale door lock model YRD226.

On the ISY-994i, I was able to set user codes in ISY and send out notifications for particular users (think housekeeper) upon unlocking the door. It appears that this functionality isn't supported under EISY/Z-Matter.

Is it possible to bring over the exact same functionality that was supported with the ISY-994i and series 500 z-wave card?

Thanks,
Blaine

There may have been something wrong when you migrated your zwave devices. I used to have that lock. Everything you're stating that's missing was/is supported. 

Edited Thursday at 02:36 PM by lilyoyo1

[dbwarner5]

Check the "children" under the main lock and users should be present. This access control is also used in programing. 

if you dont have it, then you may need to do a "interview" to get it to show up properly. See screen shots below.