Program 'Alarm!!+’ not working:

'Alarm!!+' Program – Enabled is checked and program saved

What is supposed to happen: If Insteon sensor switched ON, Set scene 'ALARM_All_Lights' = ON

Polisy Log – Sensor is switched ON - see attached

Scene ‘ALARM_All_Lights’ does not turn on when sensor is switched on

If I manually execute the 'Alarm!!+'  ‘Run Then’ the Scene turns on and notifications are sent

Ghosts in the machine... What could be wrong?

Thanks

Stew

Progam not working on sensor control - switched to ON 20260218.docx

What exactly are you using to trigger The IF clause ?

An Insteon IOLinc v.41 is connected to my alarm relay outputs. When the Alarm is tripped, the relay output closes. The IOlink registers the closure of the circuit and Polisy recognizes the switching to 'closed'. I have verified that the AC console reports the IOLinc circuit closure when the alarm is tripped and reports the circuit opening when the alarm is cleared.

Post your IF statement exactly as it appears.

'12129Td/Alarm/ALARM - Intrucsion-Sensor' is switched On.

BTW - This worked about a year ago. Recently the house alarm tripped and I realized the ALL Lights scene was not turning on.

The IOLinc is a powerline only device, if you have noise on the powerline at the time the alarm triggers the IOLinc may not send its status..

Can you put the controller log into level 3 mode and then set off your alarm and post a copy of the log.

Edited 13 hours ago13 hr by Techman

26 minutes ago, SSamuels said:

'12129Td/Alarm/ALARM - Intrucsion-Sensor' is switched On.

BTW - This worked about a year ago. Recently the house alarm tripped and I realized the ALL Lights scene was not turning on.

So it's looking for the control event, therefore it's not a status change issue. If you're seeing the status update in admin console then it's certainly getting the control event.

Level 3 log

ISY-Events-Log.v6.0.4__Wed 2026.02.18 04.17.06 PM.txt

The IOLinc's address is 42.4.E3

Your controller is seeing the status of the IOLinc

When you trigger the alarm does your program, '12129Td/Alarm/ALARM - Intrucsion-Sensor' show as red or as green in your program tree?

You might also try deleting and recreating the program.

When the alarm is trigged the program is Green.

I will try deleting and recreating.

Thanks

9 hours ago, SSamuels said:

When the alarm is trigged the program is Green.

Unless your program runs false, it will always show as green. I am not sure that we can conclude anything from this. Instead, I would look at the program summary tab and see when was the last time the program ran. If the time does not match that of the most recent alarm trigger, then it did not see the signal.

Given the evidence (log and IOLinc status) suggests that the Polisy IS receiving the IOLinc status, have you checked to see if the program somehow became disabled? Is the program in a folder that somehow because disabled?

Edited 2 hours ago2 hr by oberkc