Linking a RemoteLinc?

[bushmg]

I apologize if this dumb newby question has already been answered but I have searched and come up empty handed.

 

I have an ISY-99i Pro running v.2.7.15. I recently purchased a RemoteLinc and three dual-band LampLincs to add to my non-RF network. Currently my PLM is the older 2412S non-RF model, but I also have a 2413S dual band PLM installed simply as a phase bridge (it is not connected to the ISY). I would like to be able to use the RemoteLinc to control other scenes in the network, so I go to the Admin Console and select "Link a RemoteLinc." I put the RemoteLinc in communications mode and press OK. I then get a message to input the Name and Address (the device type is already filled in with RemoteLinc). Now here's the problem: I don't know how to tell what the RemoteLinc Address is and without that, it won't work! There is no address (i.e., xx.yy.zz) listed on the device, so what can I do? Thanks in advance for any assistance!

[Michel Kohanim]

Hello bushmg,

 

Apologies for the inconvenience. Normally, the address is on a label in the battery compartment and sometimes right underneath the batteries.

 

With kind regards,

Michel

[LeeG]

The address is located on a label affixed to the lower vertical edge of the battery compartment. The lower/bottom battery has to be removed to see it.

[bushmg]

Ouch! Boy, is my face red! Thanks to all for the rapid and helpful replies

[Brian H]

Well I was also use to the label being on the rear of the module or face plate of switches.

 

Took me awhile to find it in my RemoLincs also.

[LeeG]

They could not have a found a better location if they trying to hid it on purpose.