telljcl Posted February 3, 2011 Posted February 3, 2011 Can't figure this one out. Have imported lighting file from ISY to Elk, and can control all devices by ELK. When doing so, the ISY immediately shows the adjusted state. ISY and ELK seem to communicate normally in all other ways that I am aware of - can see ELK status across top of console etc... Whenever I physically push a button or in any way control the Insteon network (including ISY) the status or change never makes it to ELK, yet I can control any device from the ELK. I've reset both devices, deleted and re-imported the .xml device list, made sure to check all 6 serial port boxes in Global settings in ELK (5 were checked already - I checked "log" also). I am testing without ELK RP being connected, so thats not it. In the ELK lighting setup, the "option" box is checked for all devices, and the "format" is set to default-"serial expander" Any Ideas? I must be missing something simple. Thanks!
Michel Kohanim Posted February 4, 2011 Posted February 4, 2011 Hello telljcl, This does not make any sense at all because ISY uses the same socket for sending/receiving commands. Would you be kind enough to post your question in the ELK forum: http://forum.universal-devices.com/viewforum.php?f=17 With kind regards, Michel
Recommended Posts