justin.cool Posted January 6, 2012 Posted January 6, 2012 This question has probably been answered before but my attempts to search for an answer have been fruitless. I have an ISY-99i running 2.8.16, the rest of my system config is listed below. I recently installed an EZ-Flora 5010A module to replace my Rainbird unit. Initial checkout shows it is working as expected, however, there are some controls in the ISY admin console for the EZ-Flora that I don't understand: 1. What does FAST ON/OFF do with respect to the EZ-Flora? 2. What does the ramp rate and ON Level adjustment do with respect to the EZ-Flora? System Config Approximately 100 Insteon devices: • Mainly Switchlincs, Lamplincs, Outletlincs, On/Off Adapters, etc etc • 7 KPL’s • Triggerlincs (2) • RemoteLincs (3) • Controllincs (2) • ISY-99i • Access Points (4) • Dualband LampLinc dimmers (4) • Signal Linc (2) • Venstar Thermostats (3) with V2 RF interface
LeeG Posted January 6, 2012 Posted January 6, 2012 1. Fast On/Fast Off have the same effect as On/Off when controlling a Zone directly 2. Do not change On Level or Ramp Rate values. The corresponding bytes in EZFlora link records have different functions. EDIT: Fast On/Fast Off have no effect on EZFlora Zones when used in a Scene command. The EZFlora is expecting On/Off commands only in Scenes.
justin.cool Posted January 6, 2012 Author Posted January 6, 2012 LeeG, Thanks for the reply. However, I have made changes to the ramp rate and ON Levels. Now I need to get them back to where they were before and make sure they don't get changed, right? Can I manually set them back? A factory reset? Justin
LeeG Posted January 6, 2012 Posted January 6, 2012 Set On Level to 0% and Ramp Rate to 9 minutes. These values result in 00 00 in the first two data bytes in the Responder link record which is what the EZFlora is expecting for Zone control.
Recommended Posts