bobmre Posted January 21, 2013 Posted January 21, 2013 At the end of my sprinkler program I added Irrigation - Cycle Complete, which did not seem to do anything. The irrigation requirments were still the same. I had to add Irrigation - Reset Variables to clear the irrigation requirements. What does cycles complete do? Bob Moore
Michel Kohanim Posted January 21, 2013 Posted January 21, 2013 Mr. Moore, What ISY firmware are you on? With kind regards, Michel
Michel Kohanim Posted January 21, 2013 Posted January 21, 2013 Mr. Moore, Are you certain that NOTHING changed? Please note that cycle complete uses the following algorithm: Absorption Factor * Water Applied per Irrigation Cycle. So, if absorption factor is less than 100%, then the number might be too small for you to notice. I just made a simple test and it works fine here. With kind regards, Michel
bobmre Posted January 21, 2013 Author Posted January 21, 2013 I tested it again and it did change the irrigation requirement. Bob Moore
Recommended Posts