atmarosi

There is no manual reversing swtich on this fan unfortunately. I'm just puzzled at how their rf control unit is capable of reversing the fan without anything more than the same type of electronics as the fan linc. It's got AC in and out of the stock rf unit - so they must be doing something with it ..? right?

It's a minka-aire concept i Their wireless (RF based) controller will allow you to reverse it, the only physical difference between the fanlinc and the stock controller is on the output side they have a fan neutral where as the fanlinc does not...So that's why I'm thinking they are just reversing the fan circuit to spin it in reverse, all the while increasing the speed will continue to function normally no matter which way it spins.

Reason being - the fan spins the wrong way; it's going clockwise which is great for winter - not summer Would swapping the neutral/line inputs to the fanlinc do the trick at least for now?

Is it possible to reverse a FanLinc? I don't see anything directly in the ISY. If not, is there a way to use a micro switch perhaps?

Attached a screen shot of my current console. I didn't get an error message when I added the two z-wave locks, however they do not show up in my main console Looking forward to 4.1.3 when we can manage the PINS!

Correct - after adding via z-wave -> add, they (the two locks) are NOT listed on the left hand side Sent from my iPhone using Tapatalk

That was the issue - got them closer and now I was able to add them without error. Second part: how do i control them as they do not show up in the devices .....will I be able to not only fire them (open/close) but will i be able to manage the user PINs? Thanks!

Removed the failed device, excluded it, and then re-attempted to add it; attached is the log output explaining the failure. Thanks for the help! ISY-Events-Log.v4.1.2__Thu 2014.02.20 14.27.40.txt

Do i need to run the Z-Wave -> Sync to get the item added to the ISY screen following the linking process?

I attached a screen shot of the following: Help -> About Screen after adding, and attempting to sync' Z-Wave deadbolt (Baldwin) I have also attached a log of the sync output; let me know if you need anything else to help troubleshoot! Thanks Michel! ISY-Events-Log.v4.1.2__Wed 2014.02.19 22.06.33.txt

I ran into issues after a fresh install...I've reset the Zwave dongle since but not sure how to exclude the lock....

I'm having the same trouble with Baldwin Z-Wave locks :/ Any good news coming on the Z-Wave front?